Conversation

Notices

1. minute (mntmn@mastodon.social)'s status on Thursday, 08-Feb-2024 03:52:25 JST minute

   mass 3D printed parts of MNT Pocket Reform arrived today from JLC. there are 5 parts, 4 for holding battery cells and 1 trackball cup. the quality and feel of the prints is really good. we will have to glue 3 steel bearings each into 750 cups over the next weeks.

   • minute (mntmn@mastodon.social)'s status on Thursday, 08-Feb-2024 03:57:49 JST minute

     in reply to

     i did the cup in openscad and the holders in freecad, btw. if i did it again i would do all of them in openscad.

   • ✧✦✶✷Catherine✷✶✦✧ (whitequark@mastodon.social)'s status on Thursday, 08-Feb-2024 11:29:38 JST ✧✦✶✷Catherine✷✶✦✧

     in reply to

     @mntmn tried solvespace?

   • minute (mntmn@mastodon.social)'s status on Saturday, 10-Feb-2024 03:22:35 JST minute

     in reply to

     • ✧✦✶✷Catherine✷✶✦✧
     • Donty

     @donty @whitequark i really need to try solvespace again, haven't in years!

   • Donty (donty@mastodon.tetaneutral.net)'s status on Saturday, 10-Feb-2024 03:22:39 JST Donty

     in reply to

     • ✧✦✶✷Catherine✷✶✦✧

     @whitequark @mntmn Solvespace works well for my visual thinking. It was the only FOSS solution I found that made it through to my headspace!