Same picture, but at a different angle and a bit closer up.

Notices where this attachment appears

1. Niklaus 'vimja' Hofer (vimja@tooting.ch)'s status on Wednesday, 24-May-2023 05:51:49 JST Niklaus 'vimja' Hofer

   After @jacqueline told me it was possible, I tried 3d fdm printing a keycap for my mnt reform trackball. Went surprisingly well!

   Getting it to fit was a bit fiddly and not the sort of process I enjoy, but it sure beats not having just the exposed switch...