Notices by Niklas (niklasnisbeth@mastodon.xyz)

@martijnbraam @mntmn Eh, I'm doing it right now! On Linux. I couldn't say about Windows, I've only ever really used it to play Half-Life 2 - when it was new...

@martijnbraam @mntmn I might be misunderstanding you, but just if you don't know, Kicad lets you grab both the footprint origin/center and a pad and position the whole footprint based on which part you grabbed to move it. So if you grab the pad and place that in (10,10), the component center/origin will look off if that pad isn't an even fraction of a mm away from the origin. I think you can tell from the highlight when you're moving. It's not obvious at all.