Notices by minute (mntmn@mastodon.social), page 19

@johnlogic aha, 24.8 is only available in debian experimental, maybe a bit risky before tomorrow, but will check after, thanks

@Debby this is a train

did you know that libreoffice impress 24.2.6.2 cannot recognize a second display when running natively on wayland? so you can't get the presenter console? well good that i checked that before tomorrow?

solution is of course "unset WAYLAND_DISPLAY" or otherwise forcing it through xwayland 🙃

@istar wide angle shot

train to bochum

@mhoye imx8mq should work fine for that though!

@mhoye rk3588 here, though!

obviously i did all the prep on my RK3588 mnt reform

@requiem lmao i see! my experience is very distorted because i don't usually start working before 11am

also i wonder who goes somewhere at 9 in the morning to watch a talk...

i hope the hdmi output of reform will just work. i didn't get any tech rider, or any other info about the event. nada

spoiler for my talk tomorrow morning (9:15) at KiCon 2024 in bochum. still needs a bit of polishing, will do that in the train tonight. btw i like pictures

i think it crashes when moving the cursor out the window/screen while it is saving. this same problem was exhibited by inkscape a while ago

building this preso would be even nicer if libreoffice impress didn't crash all the time 🙃 at least there's a recovery button...

@CyReVolt kicad is the important thing in my question :D

@hirnsushi haha yesss

@OSEGermany @wezm it looks like the hardware sources were recently changed to CERN?

@OSEGermany ohh yeah lumenpnp looks incredible

oh, the precursor is done with altium

what are your favorite open source hardware projects using KiCAD that are _not_ by MNT?