@foone have you ever used a z-axis elastomer? They're very handy, particularly when constructing custom test sockets. It would not be a permanent solution (I assume), but would allow for testing as to whether the pitch of your ribbon cable is correct
Notices by 10,000 lb weighted blanket (violator@mathstodon.xyz)
-
10,000 lb weighted blanket (violator@mathstodon.xyz)'s status on Sunday, 04-Aug-2024 12:04:35 JST 10,000 lb weighted blanket -
10,000 lb weighted blanket (violator@mathstodon.xyz)'s status on Sunday, 04-Aug-2024 11:56:51 JST 10,000 lb weighted blanket @foone my go-to would be to solder magnet wire to each pad of interest, especially if the LCD interface doesn't consume the full 64 pin pinout