Notices by Timon 🛠 (timonsku@mastodon.social), page 2

@mntmn ah damn, get better soon!

@mntmn wasn't the model initially Fusion? In that case exporting a .usd is usually the cleanest path for getting into a mesh modeller like Blender. Retains all the good bits including materials and material colors.

@mntmn I keep thinking about it but I'm also leaving for Hackaday Berlin on the 11th and then soon after to OSHSummit gets a bit much

Revision Party is happening!
https://www.twitch.tv/revisionparty

@mntmn I often think that when doing kernel development.
But even dtoverlay fails when certain subsystems are involved that can't reload their drivers properly at runtime, it always feels like luck if reloading works or not.

Thats the dumbest fucking shit I read in this never ending mess of a trade war.

https://www.reuters.com/technology/us-china-tech-war-risc-v-chip-technology-emerges-new-battleground-2023-10-06/

#riscv #china #opensource

@mntmn ugh been there, can't wait for CM5, PIO on every GPIO would mean software fix for all low speed peripherals