Conversation

Notices

1. Piggo :verified_horse: (piggo@piggo.space)'s status on Thursday, 08-Feb-2024 20:24:36 JST Piggo :verified_horse:
   can we get a transparent filament that is really transparent after printing ... without super finicky fine tuning to get somewhat close
   • LS (lain@lain.com)'s status on Thursday, 08-Feb-2024 20:24:35 JST LS

     in reply to
     @piggo maybe it's too bumpy on the outside to be really transparent but it becomes transparent if you coat it with a clear finish?
   • Piggo :verified_horse: (piggo@piggo.space)'s status on Thursday, 08-Feb-2024 21:24:57 JST Piggo :verified_horse:

     in reply to

     • LS
     @lain the surface is one thing, but it also has tiny gaps between the infill paths if you aren't really careful with the tuning
     LS likes this.