Conversation

Notices

1. Disinformation Purveyor :verified_think: (thatguyoverthere@shitposter.club)'s status on Tuesday, 19-Dec-2023 08:42:08 JST Disinformation Purveyor :verified_think:
   Someone said if you waited about 20 minutes and used a scraper the squeeze out was easier to remove, but I ended up getting side tracked for over an hour and now there is a lot of glue to remove tomorrow when I can take the clamps off. Should have just wiped it off with a rag while it was wet. I started to and then decided to try this way.
   • Disinformation Purveyor :verified_think: (thatguyoverthere@shitposter.club)'s status on Tuesday, 19-Dec-2023 08:47:02 JST Disinformation Purveyor :verified_think:

     in reply to
     Tomorrow I have to cut the glued board into strips which will hopefully arrange neatly into a checker board end grain cutting board. I glued 2 cherry for each one maple because I don't have and 8/4 cherry
   • Disinformation Purveyor :verified_think: (thatguyoverthere@shitposter.club)'s status on Tuesday, 19-Dec-2023 11:06:40 JST Disinformation Purveyor :verified_think:

     in reply to

     • SlicerDicer
     @SlicerDicer I've never worked with teak. I haven't ever worked with anything very exotic tbh. This is maple and cherry. My friend milled the cherry.
   • SlicerDicer (slicerdicer@bikeshed.party)'s status on Tuesday, 19-Dec-2023 11:06:41 JST SlicerDicer

     in reply to
     @thatguyoverthere I’m gonna be trying my hand at teak next year.
     
     Probably gonna go ok but could be an expensive disaster.
     Disinformation Purveyor :verified_think: likes this.