Conversation

Notices

1. Disinformation Purveyor :verified_think: (thatguyoverthere@shitposter.club)'s status on Sunday, 19-Nov-2023 08:11:26 JST Disinformation Purveyor :verified_think:
   All 3 strands of LEDs are wired up, but it's dark so I'll have to wait until tomorrow to install them in the bookcase. I don't trust the double side sticky tape so I'm going to go along and bead a bit of superglue along each strip to make sure they stay put.
   
   Playing around with settings I managed to push it up to 11A of current but it's so bright I don't think I'll ever have it that high. I may just set a 10A limit in wled and leave it at that. The PSU can go up to 30 so plenty of room. I think tonight I'll just refine the wiring plan (and maybe write it down) so tomorrow it's no fuss. Right now I have a ball of wires. I may solder the esp and relay to a project board just so they are easier to manage as a unit, and for now I could mount the lamp side terminal blocks to a piece of wood. At least then everything isn't just floating around.
   • Santa Noodle ☦️ (bowsacnoodle@poa.st)'s status on Sunday, 19-Nov-2023 19:30:45 JST Santa Noodle ☦️

     in reply to
     @thatguyoverthere >Super glue
     >Pls sarr, you can get by finely with hot glue as vil see in my vidjya
     Disinformation Purveyor :verified_think: likes this.
   • Disinformation Purveyor :verified_think: (thatguyoverthere@shitposter.club)'s status on Sunday, 19-Nov-2023 19:32:23 JST Disinformation Purveyor :verified_think:

     in reply to

     • Santa Noodle ☦️
     @BowsacNoodle pobably. I just figure superglue is a little less messy and I'm really just reinforcing the doublestick tape they put on them to begin with so I want to leave plenty of surface for that to stick.