Conversation

Notices

1. Disinformation Purveyor :verified_think: (thatguyoverthere@shitposter.club)'s status on Sunday, 05-Nov-2023 06:41:16 JST Disinformation Purveyor :verified_think:
   I have a 1" router bit which would be perfect for dadoing out the shelves, but it's for a router that has a larger shank than 1/4" which afaik all 3 of my routers use. The kit looks really nice, but I don't know where the router for them is supposed to be. :Thinker:
   
   The largest 1/4" shank bit I have is 3/4" which is large enough for plywood but not quite where it needs to be for the shelves. I can either run two passes for each side of each shelf or plane them down to 3/4" and keep it simple. It probably won't be that hard to just slide the guide back a little bit and run a second pass, but it is tedious.
   • Kek Kerel (kekkerel@freespeechextremist.com)'s status on Sunday, 05-Nov-2023 08:00:38 JST Kek Kerel

     in reply to
     @thatguyoverthere You should be able to get collets in 1/2" as well.
     Disinformation Purveyor :verified_think: likes this.
   • Disinformation Purveyor :verified_think: (thatguyoverthere@shitposter.club)'s status on Sunday, 05-Nov-2023 08:00:38 JST Disinformation Purveyor :verified_think:

     in reply to

     • Kek Kerel
     @kekkerel I ended up just routing the end of the shelves so that they are able to fit into a 3/4" dado. I ran out of light tonight but tomorrow I should be able to route out the grooves for the shelves and fit everything together.