Conversation

Notices

1. minute (mntmn@mastodon.social)'s status on Tuesday, 18-Jul-2023 21:43:57 JST minute

   did you know that MNT Reform (chassis) was completely 3D printed during development?

   • minute (mntmn@mastodon.social)'s status on Tuesday, 18-Jul-2023 22:20:06 JST minute

     in reply to

     • Dr. Quadragon ❌

     @drq i think it should be

   • Dr. Quadragon ❌ (drq@mastodon.ml)'s status on Tuesday, 18-Jul-2023 22:20:07 JST Dr. Quadragon ❌

     in reply to

     @mntmn Is it still 3d-printer friendly?

   • minute (mntmn@mastodon.social)'s status on Wednesday, 19-Jul-2023 01:43:18 JST minute

     in reply to

     • /dev/loop0

     @loop0 maybe bulky area with 100% infill around the hinges? maybe nylon? or sheet metal mount for the hinges, screwed into printed part with a bigger area?

   • /dev/loop0 (loop0@freeradical.zone)'s status on Wednesday, 19-Jul-2023 01:43:19 JST /dev/loop0

     in reply to

     @mntmn I’m thinking about doing something like that, any tips I could use? My idea is to “make” a small laptop using a 10 inch ipad screen and an orange pi 5, and print the case, my concern is about the hinges, I wonder if the plastic in the case will hold up when using the hinges.