A close up of a PCB showing a mini-USB connector. The pins are instead labeled with HS, VS, B, G, R, and GND (shield)

Notices where this attachment appears

1. Foone🏳️‍⚧️ (foone@digipres.club)'s status on Monday, 07-Oct-2024 06:00:45 JST Foone🏳️‍⚧️

   in reply to

   And you can see the labels here to figure out how they ran VGA (a famously 15-pin connector) over the nominally 5-pin mini-USB port:

   horizontal and vertical syncs end up on pins 5 and 4 (Ground and USB OTG), then RGB are pins 1-3 (VCC, D-, D+). Ground ends up on the /shield/.