@mntmn I meant the hardware signal, Pin 18 on the Displayport connector.
Notices by Dirk Eibach (de@noc.social), page 6
-
Dirk Eibach (de@noc.social)'s status on Friday, 23-Dec-2022 04:23:03 JST Dirk Eibach -
Dirk Eibach (de@noc.social)'s status on Friday, 23-Dec-2022 04:13:09 JST Dirk Eibach @mntmn I think we used ST Micro flash.
-
Dirk Eibach (de@noc.social)'s status on Friday, 23-Dec-2022 04:08:24 JST Dirk Eibach @mntmn Cool. Is hotplug signal working?
-
Dirk Eibach (de@noc.social)'s status on Friday, 23-Dec-2022 03:32:39 JST Dirk Eibach @mntmn 🥳 finally. Very cool.
-
Dirk Eibach (de@noc.social)'s status on Friday, 23-Dec-2022 03:25:52 JST Dirk Eibach @mntmn so you can program it from external. Is SPI on a connector?
-
Dirk Eibach (de@noc.social)'s status on Friday, 23-Dec-2022 01:54:01 JST Dirk Eibach @mntmn Have you verified the power supply? The card seems to die in a compute intensive task. Just guessing...
-
Dirk Eibach (de@noc.social)'s status on Friday, 23-Dec-2022 01:54:00 JST Dirk Eibach @mntmn or the clock might be an order of magnitude off
-
Dirk Eibach (de@noc.social)'s status on Thursday, 22-Dec-2022 18:19:27 JST Dirk Eibach @mntmn at least the stdp flavor we used did nothing without the firmware.
-
Dirk Eibach (de@noc.social)'s status on Thursday, 22-Dec-2022 18:19:26 JST Dirk Eibach @mntmn LINDY 38146 is STDP2600 based
-
Dirk Eibach (de@noc.social)'s status on Thursday, 22-Dec-2022 06:03:05 JST Dirk Eibach @mntmn okay, so the thing is alive. But I think without the firmware it won't do much. I hope there's no NDA required. Worst case you could get a device with this chip inside and read it's SPI flash.
-
Dirk Eibach (de@noc.social)'s status on Thursday, 22-Dec-2022 05:05:49 JST Dirk Eibach @mntmn oh no, that's bad. Were did you get your firmware from?